Possible Causes
Faulty Manifold Absolute Pressure (MAP) Sensor
Manifold Absolute Pressure Sensor harness is open or shorted
Manifold Absolute Pressure Sensor circuit poor electrical connection
Faulty Engine Control Module (ECM)
الأسباب المحتملة
Possible Symptoms
Engine Light ON (or Service Engine Soon Warning Light)
Engine rough idle
Engine hesitation
الأعراض المحتملة
Description
Code P0106 Mazda Description
The Manifold Absolute Pressure (MAP) sensor measures the pressure inside the intake manifold. Pressure in the intake manifold is affected by engine speed, throttle opening, air temperature, Barometric Pressure (BARO) and if equipped, turbocharger output. A diaphragm within the MAP sensor is displaced by the pressure changes that occur from the varying load and operating conditions of the engine. The sensor translates this action into electrical resistance.
The MAP sensor wiring includes 3 circuits. The Engine Control Module (ECM) supplies a regulated 5 volts to the sensor on a 5 V reference circuit. The ECM supplies ground on a low reference circuit. The MAP sensor provides a signal voltage to the ECM, relative to the pressure changes, on the MAP sensor signal circuit. The ECM converts the signal voltage input to a pressure value.
Under normal operation the greatest pressure that can exist in the intake manifold is at ignition ON, engine OFF, which is equal to the BARO. The lowest manifold pressure occurs when the vehicle is idling or decelerating. The ECM monitors the MAP sensor signal for pressure outside of the normal range.
The Diagnostic Trouble Code (DTC) will be set when the ECM determines the MAP Sensor is stuck within the normal operating range. It accomplishes this by running 3 different models within the software to determine the values.
P0106 Mazda Code – Manifold Absolute Pressure Sensor Signal Out of Range
